Have already got netgear DG834G installed and connected to PC via ethernet cable running and working with no issues. Wi Fi Laptop also connecting to this wirelessly with no issues Needing to move PC upstairs due to disability issues. Was told that I did not have to have DG834G connected to any pc in order to share internet connection So unplugged DG834G from ethernet port on PC Installed WG111v2 onto PC when it came to configure that's where I got stuck. My wireless network is not being detected and is not showing up on the networks tab so I cannot get any further than this point what do I need to do from this stage to getting the WG111v2 working so that PC can access the internet MY OS is XP I have WEP enabled DG834G There are other wireless networks locally and these are not being detected either
Hi mrsjock, I had a similar problem and this is what I did: Press Start and run type %systemRoot%\system32\service.msc /s and then click OK Double-click Wireless Zero configuration. in the startup type list, click Automatic,and then click apply. In the service status area, click start and then click ok. .................THEN........................... click Start,click Run,type ncpa.cpl, click OK Click Network Connection In Network Connection, click to select your wireless connection, and then click Change setting of this connection on the Wireless Networks tab, click to select the Use Windows to configure my wireless network settings check box.