NO TITLE

  woodchip 17:00 29 Mar 2003

Put the new drive on the same ribbon as the other hard drive but before you do set the jumper at the back of the drive to S/L for slave. then after you are connected restart your computer. and go into setup and auto config the drive. "BUT BEFORE YOU DO ALL THIS SWITCH THE POWER OFF BY PULLING THE PLUG IN THE WALL"

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

Gamescom 2018: Announcements, livestreams and exhibitors

Hexgears X-1 review: a mechanical alternative to the Apple Magic keyboard

Beats Studio 3 Wireless review

Les meilleurs accessoires pour vélo (2018)