Configure Hyperpen 6000

  Newby 17:06 14 May 2009
Locked

I have just "dug out" my Hyperpen 6000 which I haven't used for 6 years.Acting on advise from Cable City.co.uk I bought a DB9 male to DB25 Male connector to connect my HP 6000 to the serial port. TCablrcity advised me when telling me that this connector would do the job but also said that I may have to configure start bits, stop bits, baud rate and parity. I have connected the hardware and installed the software - how do I carry out this configuration, please. Thank you.

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

Huawei MateBook X Pro review: Hands-on

The art of 'British' pulp fiction

Best password managers for Mac

TV & streaming : comment regarder le Tournoi des Six Nations 2018 ?