Seagate Barracuda 7200.9 SATA II ST3160812AS

  Giggle n' Bits 22:56 02 May 2006

Firmware was sucessfully upgraded from 3.AAD to 3.AAE to fix a known bug with compatibilty issue with a Gigabyte GA-K8N Pro SLi Motherboard.

This is a new build and a new HDD I from cold start of the pc get to the boot where the Strobe are in WinXP and it can stick there for ages like 2 or more minutes I only have WinXP, Nero, Power DVD v5, PCi Express with newest Nvidia Driver Motherboard Bios updated to F9 from F6.

But this sticking problem when starting pc is worying. So I had a look in system events logs and found Error detected on device\Hardisk0\during a paging operation

Looked at Microsoft site click here & click here

This doesn't really help me to much. Have I got a problem with the HDD or Motherboard ? I am going to run a Full Seagate Diagnostic again now which was fine last time I ran it on Sunday.

Help please.

  phil46 23:35 02 May 2006

Have you got a jumper set incorrectly? you are are showing channel 0 SATA drives are set on channel 2.

  Giggle n' Bits 23:55 02 May 2006

Where do I say I am showing Channel 0 SATA ?

  phil46 01:02 03 May 2006

Quoted the error you were showing on your thread.

  Giggle n' Bits 01:19 03 May 2006

this is the error logging info I posted above and it HDD 0

Its a SATA II Seagate Barracuda and not got jumpers.

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

OnePlus 5T review: Hands-on

Illustrator Andrés Lozano on his improv line work, brazen use of colours & hand sketching

iPhone X review

Comment envoyer gratuitement des gros fichiers ?