Resetting bios of my PB mz36-r-017

  Carley Jay 15:47 03 Aug 2007
Locked

I have enabled GFX card overclocking in the bios and now my laptop turns on but with nothing on screen, cannot access anything, are there any solutions?

  Gongoozler 18:00 03 Aug 2007

The only way I can think of to reset the BIOS is to temporarily remove the CMOS battery. This will involve some dismantling, but possible you will find the battery in the memory compartment, in which case you may only need to open a cover. There is, however the possibility that if you have overclocked the graphics you have damaged the graphics chip.

  Carley Jay 19:45 03 Aug 2007

I will try to temporarily remove the CMOS battery but i am having trouble locating my laptops disassembly guide.

  Gongoozler 12:18 04 Aug 2007

Hi Carley Jay. You'll be very lucky to find any useful documentation on anything Packard Bell. Somewhere on the bottom of the laptop you should find a panel that you can open to fit additional RAM. If you are very lucky, then you might find a small battery pack plugged in there as well.

  Carley Jay 13:11 04 Aug 2007

In the Ram area there isn't any small battery pack to remove, I want to find where the battery is on the motherboard before opening it up.

  dan* 13:30 04 Aug 2007

the manual is click here

Have you tried pressing F11 when the computer starts. Page 55. See if this will kick the screen in.

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

Fujitsu Lifebook P727 laptop review

Best of the Grad Shows 2017: University of the West of England (UWE)

Best value Mac: Which is the best £1249 Mac to buy

Les meilleures GoPro 2017