I have just bought the fabulous Altec Lansing Bluetooth inMotion Speaker but I have a problem the Charger isn't working. Well I think that is the problem. When I power the speaker up the orange power light comes on (this is suppose to be Green as the manual says)...it eventually runs out of power even thought the power lead is attached and switched on....so for me the Lead is the problem.
As I have just bought it on Friday I happened to have a Multi- volt lead which will turn the green light on but I don't know which voltage to set it at....it comes with the following settings:-
3, 4.5, 6, 7.5,9 and 12
What should I set this at? until I get another lead from the Retailer who sold me the Speaker.
The existing Altec Lansing Lead says the following:-
Output:- 6.0v ---1.5A
Maybe someone out there can understand what that means and tell me what to set the Multi-volt lead at?
Wiz-king thanks for your help it is 6 v and the the centre pin is + positive....so that seems to be working but the unit doesn't seem to be holding a charge so I think I will send it back to Amazon and get a replacement because if the truth be told I love the sound of the unit and if it was working correctly I think it would fit my use. If it was working correctly I would thoroughly recommend it for sound....in my opinion it would be as good as a Bose Dock but much cheaper at £70. Hopefully it is only a faulty unit and not a faulty design otherwise (I wouldn't recommend it so readily).
Thanks again for your help....much appreciated
This thread is now locked and can not be replied to.