P.C. wont start up, ( NO SIGNAL )

  DrLector 10:01 21 Sep 2003
Locked

Hello
i TURND MY PC OF AT THE MAINS YESTERDAY TO INSTALL
MY NEW PRINTER, BUT WHEN I TURND POWER BACK ON
ON THE PC STARS UP BUT THE MONITOR JUST COMES UP WITH -
" NO SIGAL
12 PRESET MODE
MAX.16 USER MODE
4 COLER MODE
ENERGY STAR
DDCI/25
MPR11 (N TCO)"
IV TRYED ALL THE DIFRENT COMBANASHONS I CAN THINK OF, PC ON FIRST THEN MONITOR,MONITOR AND PC AT THE SAME TIME, BUT I JUST KEEP GETING THE SAME THING, THIS ALLSO HAPEND TO ME ABOUT A MONTHAGO,
I TRYD ALL NIGHT TO START IT AND THE NEXT DAY I JUST WORKD FINE,NO LUCK TODAY,
LUCKLY I HAVE MY DADS PC TO WRIGHT THIS LETTER,
BUT I RELLY NEED MY PC BACK ASAP
THANKS FOR ANY HELP
T.

  BurrWalnut 10:10 21 Sep 2003

This type of message usually appears when there is a bad connection on the monitor cable. Make sure it is fully pushed in at the back of the computer and the 2 screws tightened.

  -pops- 10:13 21 Sep 2003

Please don't write in capital letters

No Signal usually indicates that the computer is not connected to the monitor. Does the computer seem to be running OK? (Getting the POST beep etc?)

Check the cabling between computer and monitor in the first instance. Unplug and plug in again if necessary.

  MAJ 10:17 21 Sep 2003

Also, if you have another monitor handy, try that in place of the faulty monitor.

  Bodi 10:23 21 Sep 2003

you may well need to renew your monitor cable - if you can. If it's a permanent connection to monitor, would need taking to a proper repairer - don't open up monitor. You could check the pins in the end connector and make sure none are bent.

Otherwise agree with all above.

Bodi

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

OnePlus 5 review

Alice Saey's mesmerising animation for Dutch singer Mark Lotterman

iPad Pro 10.5in (2017) review

Comment booster votre iPhone ?