No beep on new mobo

  Taw® 19:09 05 Nov 2004
Locked

Just fitted a new mobo expo cu133 and PIII 1.13. have set switch as shown in manual but on booting all I get is power, no boot sequence or beeps. Am I missing something really easy, or how would I know how to go about troubleshooting?

  [email protected] 19:19 05 Nov 2004

I would check the ram is seated properly--usually the problem with no beeps.
Failing that you should clear cmos and try rebooting [instructions to clear cmos will be in mobo manual ]

hope that helps.

  Dorsai 19:24 05 Nov 2004

An AGP card that has not seated fully can also give this problem. So double check it has gone all the way in. AGP slots on new Boards can be really very stiff to insert the card into.

  PA28 20:04 05 Nov 2004

Have you connected your speaker to the right pins?........

  Taw® 20:19 05 Nov 2004

Have tried your suggestions folks but no joy. My PIII is a tualatin the ad for the mobo said it would support it, but the manual just says for coppermine, I think it may be a case of trying an ordinary PIII

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

Best Black Friday Deals 2017

How modern book design was influenced by illustrated manuscripts

Best Black Friday Apple Deals 2017

Les meilleurs logiciels de montage vidéo gratuits (en 2017)