I have just fitted a new hard drive, as a slave.The ribbon going to the first installed drive has slave marked on it so I just connected it to the new slave drive.All the system programs are still on the other original c drive which is as it was before the slave was put inWin XP says new hard where detected but thats all.I cant see anything except the C: in My computer.The new drive is a Samsung 80 Gig and the original is a 40 Gig ,Samsung as well I think.Any help please.
Did you set the jumpers on your new drive to 'slave' config?
You will have to go into disk management and format the drive .
Dan Yes it as slave.RayukHow do i go into disk management
Start/run type indiskmgmt.mscpress enter
Rayuk. Im in disc management and can see disc 0 and the new disc 1.says unallocated.Theres a red spot on it though.How do i now fromat etc
Right clk red spot & initialise first,then partition.
Les.I did the right click and initialise.The red spot as now gone and when i right click now it says properties.How do i now partition.
If I remember,right clk on the disk space & chose partition.
This thread is now locked and can not be replied to.
OnePlus 5T review: Hands-on
See the Best Button Badge Designs of 2017
iPhone X review
Black Friday 2017 : date, sites participants & bonnes affaires
© Copyright 2017 IDG UK. All Rights Reserved.