I have a Maxtor harddrive wich I am trying to set as slave but I don't know how to reset the jumpers.At present it works fine (from left to right) with one jumper verical and the next one horizontal across across the next top pins.How do I set the jumpers for slave?Any help greatly appreciatedRegards,Jez
Maxblast click herea good tool for maxtor hard drives also shows jumper settings for all maxtor harddrives
With most Maxtor hdd's the jumper settings are shown on the top or near the jumper pin's.
Usually you take the jumpers out to turn a maxtor to slave. Is the drive limited to a certain capacity. i.e. the horizontal jumper.click hereThe information is always on the top of the hard drive. If it has a rubber cover, just peel it off.
Agree with above. On most Maxtor hard drives the slave setting is usually without any jumpers fitted.See this website for links click here
The Maxblast 4 For Windows disk cloning and partitioning application is available from Maxtor on this webpage click here
Maxtor jumpers click here
This thread is now locked and can not be replied to.
Best phone camera 2017
Stunning new film posters by Hattie Stewart, Joe Cruz & more
iPad Pro 10.5in (2017) review
Comment faire une capture d’écran sur un Mac ?
© Copyright 2017 IDG UK. All Rights Reserved.