Alienware 17 R4 2017 review
Hi, can anyone give me some ideas? Have an MSI K8T NE02 motherboard and a sata drive. Trying to install xp it goes through the first part of the install and when it re-boots comes up with a blue screen fatal error!!!!
Tried to install on a usb external drive with the same problems. Ta very much
Installing XP on SATA drive
Once you have the drive(s) connected you are ready to start installing XP.
Master and Slave
Remember since it's serial you can only have one device per SATA port/cable so SATA drives don't have jumpers. On the Motherboard SATA1 Port is for the primary device, SATA2 port is for the secondary device etc.
SATA controller driver
Your Motherboard or SATA controller card requires a driver to work properly. Drivers may be written into BIOS, Try and see if windows CD can see the drive, if not then the SATA drivers can be located on the installation CD that came with your Motherboard or preferably, download the latest SATA controller drivers from the manufacturers site. Once you have located the drivers copy them to a formatted floppy disk. Make sure they are in the root directory i.e. not contained within any folders. If you did not get a Floppy Disk with the SATA driver included with your Motherboard you may have to make one.
When you turn on the PC hit the Delete key when prompted and you will enter the BIOS (Basic Input Output System). Here you set the first boot device to be the CDROM drive, the option is usually found under the Advanced Options section but this depends on your BIOS and you may have to look around for it. Once you have done this save and exit.
Installing the SATA controller driver
Once you have set the PC to boot from the CD make sure the XP CD is in the CD drive and start the installation as per usual. Within the first minute or so of the installation Windows will prompt you to press F6 to install RAID or SCSI drivers, do this. Windows will continue to install then ask you to locate the driver. now with the floppy disk created earlier in drive A: select the driver and hit Enter.
With the SATA drivers installed you can now continue the Windows installation as usual.
BIOS settings revisited
Once Windows has finished installing you will need to make sure the PC is set to boot from the SATA drive. To do this make the first boot device SATA if the option is available. If not you have two options: HD0 - If there are no IDE HDs present, or SCSI if you do plan on running an IDE HD as a secondary device.
This thread is now locked and can not be replied to.