Help with Thomson TUTV DTR

  maco2078 17:58 03 May 2009

I went out and came back and switched on the DTR and it would not come on. I noticed the amber light was on. I fiddled about pressing buttons and turned it off at mains.

Looked in book, says nothing about lights in the troubleshooting guide.

However, it odes say at set up if an amber light is on it is updating.

It is not only an amber light but every so often a little green light flashes on/off and then a few small lights come on altogether.

But in the main it stays amber.

It also said NOT to press any buttons whilst it is updating but I didn't know, just assumed it wasn't working.

I suppose I'd best leave it and see if the red light comes back on eventually and if not switch it of for a bit and reboot.

Anyone know any different?

  Devil Fish 23:50 03 May 2009

had this with mine the following worked for me with my DTI6300-16

unplug power cable

hold standby button on the box reinsert power cable

when red light shows release standby button then in quick succesion press menu and ok on the box leave for 10 mins this should reset to previous software

hope this is of some help

  maco2078 07:25 04 May 2009

Hi. I will try this. I have also tried another method which was unsucccesful.

Let you know how it goes.

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

Galaxy Note 8 vs iPhone X

The secrets of creating gory VFX

How to update iOS on iPhone or iPad

WhatsApp : comment lire vos messages sans que l’expéditeur le sache