epson c80 printer

  User-EEEE1D5E-719D-4EA6-9E34518ECB10F723 13:31 11 Dec 2004

epson c80 stopped printing /will not print anything / new ink cartrgs/ used cleaning system/ no change/ printer run normal except will not print. is there any adjustments on these or reset options // ?

  JaßîsFaß ˜ 13:46 11 Dec 2004

Have you tried a test print? Turn both computer and printer. Then turn on the printer holding down both the 'paper' button and the 'on' button at the same time, then release the on button, when the nozzle check starts release the paper button. Does it print a test page?

  JaßîsFaß ˜ 13:47 11 Dec 2004

Sorry first line should say 'Turn both computer and printer off'. ..

  Dorsai 14:01 11 Dec 2004

What actually happend when you try and print somthing?

Do you get a blank page out of the printer?

Does it start to print, get say 3cm printed, then freeze, eventually followed by a comunication error?

Does the printer do nothing at all?

Is perhaps the printer set to 'work offline', in which case windows is just saving the doc's to disk, and waiting for you to tell it that the printer has been turned back on.

The first thing i would do is open the printes folder in control panel, and see if the printer icon is 'greyed out' If it is, right click on it, and there may be a tick against 'use printer offline' if so, make sure the printer is turned on, and then left click on 'use printer offline'

It then *should* start printing all the stuff you have printed out.

  JaßîsFaß ˜ 10:49 22 Dec 2004

Have you resolved from these suggestions?

  JaßîsFaß ˜ 10:46 31 Dec 2004

Please update if resolved

  Fruit Bat /\0/\ 12:16 31 Dec 2004

I hope this helps some of you who are frustrated and ready to throw out your Epson printer

Recently had problems with my Epson C40UX printer, the red and green light began flashing and a window popped up, saying, take it to your services center because some parts have reached the end of their life. Instead I did a bit of reading and I was successful. You see printer companies set a “protection counter” on all printers , it’s an internal counter measuring the amount of ink wasted by head cleaning. I needed to reset the "protection counter" as well as clean the “waste ink pad overflow”.

Following is the procedure that I used:

1. Unplug the power and USB cables from the printer. I pried open my C40UX printer, careful not to break anything. I use a flat blade screwdriver to pry it apart; there are two-three tabs at the back and two at the front. Gently push them in, and then using a bit of force pry apart the cover.

2. Next I removed the two (2) waste ink pads. They are located at the back on the left hand side. I used the flat blade screwdriver to lift up the ink pads (they were soaked). Please use rubber gloves as it gets very messy.

3. Next I took the pads to the kitchen skin and washed them with just plain hot water until they
were white again. I just let the hot water run on them (the pads are about three inches long).

4. Once washed I dried them using a hair drier. (you could place it the sun for a few hours or on top of your heater or maybe in a heated oven; (make sure you do not set it on fire with too much heat).

5. Once dried I placed the pads back in the ink waste bin at the back of the printer.

6. I closed the printer cover and put back all the pieces and plugged in the USB & power cable and turned it on. (Yes the lights are still flashing).

7. Go to this link and download this software: click here

8. Install the software and run it.

9. Select your printer and model number ( It only says C40 there is no UX, choose it anyway).It will ssk if you replaced with new pads; say “YES”. Then close the window.

10. Now right click on the SSC service utility, it looks like a printer icon near your clock in the task bar.

11. Then click on reset counters. You can do all other stuff with this utility too.

12. Turn off the printer power and then turn it on again. If necessary un-plug the power cord from the back of the printer, wait 20 seconds. Plug it back in.


This thread is now locked and can not be replied to.

Elsewhere on IDG sites

Fujitsu Lifebook P727 laptop review

11 best portfolio websites for designers and artists

Office for Mac buying guide: Price, Office 2017 rumours & new features

Comment désactiver les programmes qui s'exécutent au démarrage de Windows 10 ?