epson C44

  SLAYER 19:22 17 Mar 2007
Locked

this printer has been a stalwart,always ready to to my bidding.Got myself a R265,works fine.Use it for cd/dvd printing.

to cut a long story short.The C44 tells me it needs a service,why ,god knows,downloaded SSC service utility.How do I use it. C44 has plenty of life,how come Epson says different.

  woodchip 19:39 17 Mar 2007

Inside the printer there may be a small battery also there is a clock counter the counter needs clearing. Select your printer from drop down list before doing the above

  Fruit Bat /\0/\ 19:40 17 Mar 2007

Problems with my Epson printer, the red and green light began flashing and a window popped up, saying, take it to your services center because some parts have reached the end of their life.

Printer companies set a “protection counter” on all printers , it’s an internal counter measuring the amount of ink wasted by head cleaning.

Reset the "protection counter" as well as clean the “waste ink pad overflow”.

1. Unplug the power and USB cables from the printer. Pry open the printer, careful not to break anything. Use a flat blade screwdriver to pry it apart; there are two-three tabs at the back and two at the front. Gently push them in, and then using a bit of force pry apart the cover.

2. Next remove the two (2) waste ink pads. They are located at the back on the left hand side. I used the flat blade screwdriver to lift up the ink pads (they were soaked). Please use rubber gloves as it gets very messy.

3. Next wash them with just plain hot water until they are white again. I just let the hot water run on them (the pads are about three inches long).

4. Once washed dry them using a hair drier. (you could place it the sun for a few hours or on top of your heater or maybe in a heated oven; (make sure you do not set it on fire with too much heat).

5. Once dried place the pads back in the ink waste bin at the back of the printer.

6. Closed the printer cover and put back all the pieces and plug in the USB & power cable and turned it on. (Yes the lights are still flashing).

7. Go to this link and download this software: click here

8. Install the software and run it.

9. Select your printer and model number ( It only says C40 there is no UX, choose it anyway). It will ask if you replaced with new pads; say “YES”. Then close the window.

10. Now right click on the SSC service utility, it looks like a printer icon near your clock in the task bar.

11. Then click on reset counters. You can do all other stuff with this utility too.

12. Turn off the printer power and then turn it on again. If necessary un-plug the power cord from the back of the printer, wait 20 seconds. Plug it back in.

13. IT WORKS AGAIN.

  SLAYER 08:44 19 Mar 2007

Perfect.
Old faithful back up and running.
Thanks.

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

Best phone camera 2017

Stunning new film posters by Hattie Stewart, Joe Cruz & more

iPad Pro 10.5in (2017) review

28 astuces pour profiter au mieux de votre iPhone