OnePlus 5 review
Help, whenever I try to install medal of honour spearhead it sicks at 28% and I get the same message "data error cyclic redundancy check" please help
The cyclic redundancy check (CRC) error is generic in nature and can be caused by numerous factors. The following list contains the most common reasons for this error and potential ways to resolve the problem:
1. Contaminated read/write heads of the tape device:
Check with the hardware manufacturer for proper cleaning techniques.
2. Bad media:
Replace the media. Try a new tape that is certified by the hardware manufacturer.
3. Tape driver:
Load the appropriate Backup Exec tape driver. The latest Backup Exec tape drivers can be downloaded from the VERITAS Technical Support Web site at click here .
4. SCSI controller wide negotiation enabled:
Use the manufacturer's SCSI setup program to disable wide negotiation on the SCSI controller card.
5. SCSI controller wide negotiation:
If the device is a wide (68 pin) SCSI device, then wide negotiation may and should be used. If the device is a narrow (50 pin) SCSI device, disable wide negotiation.
6. SCSI controller transfer rate is too fast:
Use the manufacturer's SCSI setup program to lower the SCSI transfer rate. Check with the controller and backup device manufacturer for the proper configuration for SCSI transfer rate.
7. SCSI controller synchronous negotiation enabled:
Use the manufacturer's SCSI setup program to disable synchronous negotiation on the SCSI controller card. Check with the controller and backup device manufacturer for the proper configuration for SCSI synchronous negotiation.
8. Incorrect termination or bad cables:
Verify that the SCSI cable is good and is configured to provide proper SCSI termination. Do not mix passive and active termination.
9. Confirm that the tape drive is functioning properly:
Check with the tape drive manufacturer for diagnostic software to test the condition of the tape drive hardware.
10. General SCSI problems:
Isolate the tape drive on its own controller card.
although it refers to tapes, the same information can be applied to cd's
This thread is now locked and can not be replied to.