BT Voyager 2110+1040-Configure failure

  lenc 19:53 16 Jan 2006
Locked

I am in the process of setting up my wireless network, using BT Voyager 2110 and 1040. AP setup went OK as did installation of adapter. I then used the supplied utility to connect my PC to the AP and that said it was OK. I then tried to connect my browser to the AP and it failed to connect. I have restarted my PC, several times, and done a hard reset on the AP and it continues to fail. Doing 'Repair' in the setup utility goes along fine until it 'fails to renew my IP address'. Suggestions?

  lenc 12:50 17 Jan 2006

Solution is simple in the end. Original configure used a mis-typed WEP key. Correcting this fixed the problem.

This thread is now locked and can not be replied to.

Elsewhere on IDG sites

OnePlus 5 review

Alice Saey's mesmerising animation for Dutch singer Mark Lotterman

iPad Pro 10.5in (2017) review

Comment booster votre iPhone ?